Prvni ulozeni z chegewara githubu

libraries/USB/examples/KeyboardAndMouseControl/KeyboardAndMouseControl.ino

@@ -0,0 +1,101 @@
+/*
+  KeyboardAndMouseControl
+
+  Hardware:
+  - five pushbuttons attached to D12, D13, D14, D15, D0
+
+  The mouse movement is always relative. This sketch reads four pushbuttons, and
+  uses them to set the movement of the mouse.
+
+  WARNING: When you use the Mouse.move() command, the Arduino takes over your
+  mouse! Make sure you have control before you use the mouse commands.
+
+  created 15 Mar 2012
+  modified 27 Mar 2012
+  by Tom Igoe
+
+  This example code is in the public domain.
+
+  http://www.arduino.cc/en/Tutorial/KeyboardAndMouseControl
+*/
+#if ARDUINO_USB_MODE
+#warning This sketch should be used when USB is in OTG mode
+void setup(){}
+void loop(){}
+#else
+
+#include "USB.h"
+#include "USBHIDMouse.h"
+#include "USBHIDKeyboard.h"
+USBHIDMouse Mouse;
+USBHIDKeyboard Keyboard;
+
+// set pin numbers for the five buttons:
+const int upButton = 12;
+const int downButton = 13;
+const int leftButton = 14;
+const int rightButton = 15;
+const int mouseButton = 0;
+
+void setup() { // initialize the buttons' inputs:
+  pinMode(upButton, INPUT_PULLUP);
+  pinMode(downButton, INPUT_PULLUP);
+  pinMode(leftButton, INPUT_PULLUP);
+  pinMode(rightButton, INPUT_PULLUP);
+  pinMode(mouseButton, INPUT_PULLUP);
+
+  Serial.begin(115200);
+  // initialize mouse control:
+  Mouse.begin();
+  Keyboard.begin();
+  USB.begin();
+}
+
+void loop() {
+  // use serial input to control the mouse:
+  if (Serial.available() > 0) {
+    char inChar = Serial.read();
+
+    switch (inChar) {
+      case 'u':
+        // move mouse up
+        Mouse.move(0, -40);
+        break;
+      case 'd':
+        // move mouse down
+        Mouse.move(0, 40);
+        break;
+      case 'l':
+        // move mouse left
+        Mouse.move(-40, 0);
+        break;
+      case 'r':
+        // move mouse right
+        Mouse.move(40, 0);
+        break;
+      case 'm':
+        // perform mouse left click
+        Mouse.click(MOUSE_LEFT);
+        break;
+    }
+  }
+
+  // use the pushbuttons to control the keyboard:
+  if (digitalRead(upButton) == LOW) {
+    Keyboard.write('u');
+  }
+  if (digitalRead(downButton) == LOW) {
+    Keyboard.write('d');
+  }
+  if (digitalRead(leftButton) == LOW) {
+    Keyboard.write('l');
+  }
+  if (digitalRead(rightButton) == LOW) {
+    Keyboard.write('r');
+  }
+  if (digitalRead(mouseButton) == LOW) {
+    Keyboard.write('m');
+  }
+  delay(5);
+}
+#endif /* ARDUINO_USB_MODE */