arduino-esp32-custom-lwip-ppp-enabled/libraries/RainMaker/examples/RMakerCustomAirCooler

ESP RainMaker Custom Device

This example demonstrates how to build a custom device to be used with ESP RainMaker using Mode, Range and Toggle Parameters.

What to expect in this example?

• This example sketch uses the on board Boot button and GPIOs 16, 17, 18, 19, 21, 22 to demonstrate an ESP RainMaker AirCooler device.
• After compiling and flashing the example, add your device using the ESP RainMaker phone apps by scanning the QR code.
• Toggling the power state from the phone app will toggle GPIO 16.
• Pressing the Boot button will toggle the power state (GPIO 16) and the same will reflect on the phone app.
• Toggling the swing state from the phone app will toggle GPIO 17.
• Changing the mode from the phone app will toggle the GPIOs 18 (auto), 19 (cool) and 21 (heat)
• Changing the Speed slider from the phone app will dimming GPIO 22
• You can also change the Level from the phone app and see it reflect on the device as a print message.

Output

Received value = true for Air Cooler - Power
Received value = false for Air Cooler - Power
Received value = true for Air Cooler - Swing
Received value = false for Air Cooler - Swing
Received value = 0 for Air Cooler - Speed
Received value = 255 for Air Cooler - Speed
Received value = Auto for Air Cooler - Mode
Received value = Cool for Air Cooler - Mode
Received value = Heat for Air Cooler - Mode
Toggle power state to false.
Toggle power state to false.

Resetting the device

• Press and Hold the Boot button for more than 3 seconds and then release to reset Wi-Fi configuration.
• Press and Hold the Boot button for more than 10 seconds and then release to reset to factory defaults.